Hardware
Can an Infusion enclosure be mounted horizontally?
Vision Parts Request
Can I hook up non-dimable loads to a dimming module? Motors, non-dim ballasts, etc.
Can manual override be used with Q jumpers?
The wrong number of modules is reported in the Master's LCD display. Modules are not responding in Manual Override.
Where is the serial number located on a keypad?
Landscape lighting or other load is tripping some GFI breakers or GFI outlets.
A Motion Sensor does not work when programmed correctly.
V commands do not seem to be triggering the Vantage System. RS-232 is not communicating.
How much power do Master and Slave controllers draw.
Does Vantage have 15 Amp fuses to run loads?
Vantage UL Listed Information
Heating Effects of Vantage Components
InFusion Controller displays as Controller number 9, even when the address dials are set to Controller number 1
Upgrading Q Systems to InFusion Systems
RadioLink Guidebook Revision 2
Can an Infusion enclosure be mounted horizontally?
Vision Parts Request
Can I hook up non-dimable loads to a dimming module? Motors, non-dim ballasts, etc.
Can manual override be used with Q jumpers?
The wrong number of modules is reported in the Master's LCD display. Modules are not responding in Manual Override.
Where is the serial number located on a keypad?
Landscape lighting or other load is tripping some GFI breakers or GFI outlets.
A Motion Sensor does not work when programmed correctly.
V commands do not seem to be triggering the Vantage System. RS-232 is not communicating.
How much power do Master and Slave controllers draw.
Does Vantage have 15 Amp fuses to run loads?
Vantage UL Listed Information
Heating Effects of Vantage Components
InFusion Controller displays as Controller number 9, even when the address dials are set to Controller number 1
Upgrading Q Systems to InFusion Systems
RadioLink Guidebook Revision 2